Delaware Concealed Carry Forum

General Gun Discussion => Gunsmiths Corner => Topic started by: Willie848 on June 24, 2012, 09:44:58 PM

Title: Hand grip from plastic to rubber.
Post by: Willie848 on June 24, 2012, 09:44:58 PM

Hey guy's just want know if anyone have any info. on how to replace the plastic hand grip on a Smith & Wesson 908. No screws afraid to force and pry them off anyone ever replaced hand grips on the 908 semi auto pistol.   

Title: Re: Hand grip from plastic to rubber.
Post by: Adrenolin on July 03, 2012, 03:03:10 AM

It can be a pita as they are on quite tight. First you need to remove the pin on the lower rear corner of the grip. Using a punch you should be able to push it through and out by hand however a few taps from a mallet may be required to start it. Once the pin is removed the grip itself slides off rearward but again its on very tightly so a bit of persuading may be needed to assist it. Hope this helps.

Title: Re: Hand grip from plastic to rubber.
Post by: Willie848 on July 05, 2012, 03:59:41 PM

Thanks got the new pistol grips about a week ago. They were very very easy to install and they look and fill great,thanks for your help.

Title: Re: Hand grip from plastic to rubber.
Post by: Adrenolin on July 05, 2012, 04:33:04 PM

Gladly. Happy it helped.  :)