Author Topic: Hand grip from plastic to rubber.  (Read 6312 times)

Willie848

  • Member
  • ***
  • Posts: 76
Hand grip from plastic to rubber.
« on: June 24, 2012, 09:44:58 PM »
Hey guy's just want know if anyone have any info. on how to replace the plastic hand grip on a Smith & Wesson 908. No screws afraid to force and pry them off anyone ever replaced hand grips on the 908 semi auto pistol.   

Adrenolin

  • Life Member
  • *****
  • Posts: 1494
Re: Hand grip from plastic to rubber.
« Reply #1 on: July 03, 2012, 03:03:10 AM »
It can be a pita as they are on quite tight. First you need to remove the pin on the lower rear corner of the grip. Using a punch you should be able to push it through and out by hand however a few taps from a mallet may be required to start it. Once the pin is removed the grip itself slides off rearward but again its on very tightly so a bit of persuading may be needed to assist it. Hope this helps.

Willie848

  • Member
  • ***
  • Posts: 76
Re: Hand grip from plastic to rubber.
« Reply #2 on: July 05, 2012, 03:59:41 PM »
Thanks got the new pistol grips about a week ago. They were very very easy to install and they look and fill great,thanks for your help.

Adrenolin

  • Life Member
  • *****
  • Posts: 1494
Re: Hand grip from plastic to rubber.
« Reply #3 on: July 05, 2012, 04:33:04 PM »
Gladly. Happy it helped.  :)